Hero image

9Uploads

537Views

96Downloads

KS3 introduction to drawing methods Graphics - Quick Test
peanutwarriorpeanutwarrior

KS3 introduction to drawing methods Graphics - Quick Test

(0)
A quick 30 minute test that enables students to demonstrate prior knowledge. Print off the second sheet give one to each student. Don’t allow them to do the test, instead insist on giving them 2-3 minutes on each task, have the sheet projected on the board and give them hints if need be to start them off. they can’t move on to the next one unless you say so, as you walk around the room give the students a mark 1 if they have a few lines in place 2 if it’s mostly complete par a line and 3 if they are correct. Used this for many years and always seems to engage the students as it’s a fast way of students being graded and seeing progression. Answers are on the third sheet, usually have a student draw the missing lines on the board.
Kitronic USB lamp Circuit board Housing
peanutwarriorpeanutwarrior

Kitronic USB lamp Circuit board Housing

(0)
An .STL that contains a printable housing for a completed lamp circuit board from Kitronic. Print off in position shown no supports needed. https://kitronik.co.uk/collections/electronic-project-kits/products/2131-colour-changing-usb-lamp-kit
Logo Labelling
peanutwarriorpeanutwarrior

Logo Labelling

(0)
25 logos for students to answer, makes a nice starter or talking point introducing logos. Answers included.
Bobble Head design sheet and net (no glue needed) Print off on A3 or Laser cut with 2D Design
peanutwarriorpeanutwarrior

Bobble Head design sheet and net (no glue needed) Print off on A3 or Laser cut with 2D Design

(0)
Created these a few years back now but still use them and are always a hit with students. The bobble head net had gone throw numerous changes to enable it to easily be put together without the need of glue. Ideally you would be best laser cutting out the Techsoft 2D Design file included, however you can just about fit the net onto a piece of A3 card so an option is to print or photo copy. Included is a basic sheet with outlines of a bobble head so students can be as creative as they like.
Mini trophies for students
peanutwarriorpeanutwarrior

Mini trophies for students

(0)
A 2D Design file containing 4 trophies and 1 medal design. Save time creating your own and adapt these to suit. You will need Techsoft 2D Design to access the file. Clear Acrylic, 3MM works best, may have to adjust your tolerances on the opening on each base to ensure tight fit.